Creative Woodworks & crafts 1999-01, страница 32

Patterns V Located in Full Size Pattern Section i No. 1! A

instructions

| Cut to shape

| Trim the patterns, spray the backs with adhesive, p

■ and attach to the wood pieces, matching up the S; guide lines on one pattern piece to the correspond- §|

I ing lines on the other.

1 Cut the front or top view of the pieces first, since || | these are usually the thickest and most difficult cuts % | to make. Make all inside cuts, then the exterior ||

• ones. After each cut is made, use masking tape to f| | secure the cut piece back into the block to help

| reduce breakage.

Once all front and top view cuts have been made, f I proceed to the side or bottom view cuts.

Once all cuts have been made, remove the mask-| ing tape and waste pieces. The piece can be left in ; this rough state or you can round the edges by sand- _;j f ing. Cover all surfaces of the pieces with wood seal-| er and allow to dry.

| Painting

Mix two parts of Spice Brown to one part of Bambi ;

• Brown and paint the entire moose. Paint the antlers, H | nose, and hooves Burnt Umber. Allow paint to dry, J| s then with the permanent marker, add in all detail

■ linework.

Glue the chair parts together and allow to dry, then paint Bright Red and let dry (see the exploded view drawing). Glue the moose to the chair.

Coat both the moose and chair with high gloss varnish and allow to dry.

With the string of miniature light bulbs, wind around the moose and his antlers as desired and spot glue into place. {ft