Creative Woodworks & crafts 2000-01, страница 20

Patterns Located in Full Size Pattern Section No. 2!

by Phillip and Donna Racine

jajgig&g

i ll li Wood: red oak—two pieces iff W 9/16" x 1 -1/2" x 8" (for the top :p and bottom), six pieces 1/4" }\ x 8-1/2" x 16-1/2" (for the

;§§ II ^sides)

'P H Tools: scroll saw or table saw; i|| |j drill with bits; router with 3/8"-ff }| Dia. rabbet bit If l! 1/8" x 8-1/2" x 16-5/8" mirror p, | 8-5/8" x 16-5/8" cardboard I? {j backing

| | Eight 3/16" x 7/8" wooden | j| dowels I p Fourteen 3/4" brads I' l| Temporary-bond spray || jf adhesive |i |[ Wood glue

|| Sandpaper, assorted grits |i s[ Clear acrylic sealer or finish of |p |{ choice

ft- |i Sawtooth hanger (optional)

■

' : : §M$m

■ ■ ■

| INSTRUCTIONS

I Cut wood to size and sand as §; needed. Attach patterns to the fr wood using spray adhesive and cut |5 along pattern lines.

| Glue the sides

If- Lay pieces out before gluing. | Place glue on both sides of pieces % B, C, D, and E and assemble s|. according to the Assembly View If:; Drawing.

| Drill holes for doweis and key i hole as indicated on the pattern. | Note: the key hole is optional, a | sawtooth hanger can be attached | instead. Assemble the top, bottom, | and sides by inserting the dowels | (see the Cutaway View Drawing). | Using a rabbeting bit, rabbet a | 3/8" wide x 5/16" deep groove I along the inside edge for the mirror | and cardboard backing. Sand the | back as needed.

Apply finish of choice according | to manufacturer's instructions, then I; install the mirror and cardboard | backing with brads. Attach optional sawtooth hanger and display.

WM I

mm-■

SHr- :

...

mm

continued on page 22