Creative Woodworks & crafts 2001-06, страница 87
Upright Face Piece Panel Size - A'' x 3-%" x 5-%" Make from hard maple Registration mark (typ) Plate No. 1 / \ \ \ \ VV\ \ Arrow indicates - grain direction Drill on dashed line •' / ■ i i Cutting path direction Counterclockwise % Make inlay from walnut Plate No. 4 \ / \ \\ Arrow indicates grain direction A Drill on dashed line | Cutting path direction Counterclockwise Make inlay from pan amarillo Full Size Patterns Wildlife Lamp from page 14. Bottom (P) make one /" x 0-54" x 0-54" hull Size fat-terns Prifting from page 56, Plate No. 3 Plate No. 2 V / X \ / / f \ \ / X \ \ Prill on dashed lint Arrow indicates grain direction Arrow indicates grain direction Cutting path direction r Counterclockwise Prill on dashed line 11ILJ jr Make inlay from chakte-coc Cutting path direction Counterclockwise i .........xJfc___________ Make inlay from cherry .....J Plate No. 5 \ Place drill bit on inside of solid black line and drill at an angle approximately the \ same as the tilt of \ \ V
\ j Arrow j indicate grain di recti oi z Cutting path direction Counterclockwise Prill small pilot hole for reference mark on center After upright is cut out, use a 1-%"-Dia. Forstner bit to drill hole to proper depth to accept mini clock insert. w V Make inlay from mahogany Uc / Loc. of side (typ) Top(B) make one V" x 7-%" x 7-%" Bore %"-Dia. hole to insert lamp rod Adjust slots, if necessary, ....... for the thickness of material used urn uricj Pattern Nomenclature Gray Lines - Represents the complete pattern showing the sawyer all of the lines for reference (PO NOT cut these lines). Solid and dashed lines as one path - This type of pattern line tells the sawyer that there will be another inlay piece overlaid onto this section that contains the dashed lines only. The dashed lines (also referred to as the safe area to drill at a perpendicular angle) also tell the sawyer that he can drill a pierce hole on this line because it will be covered up by another piece in the future. 5olic black line as one path - This type of line indicates that there will be no other piect overlaid onto it. The sawyer now has to place his drill bit to the inside of the pattern line and drill at an angle of apprsxlmately the same tilt as the scroll saw table so that the drill hole will not be seen, (See illustration—pierce cuts with no overlays.) Full Size Patterns Tipperary Shelf and Photo Frame from page 42, FULL 6IZE PATTERN SECTION NO. 2 JUNE 2001
Metric Conversions: 1 inch = 25.4mm = 2.54cm = 0.0254m
Top Overlay (A) make one V" x 0-54" x 0-%" / Dashed iine indicates ^ placement of Top (B) Bore %"-Pia. hole to insert lamp rod Center for No. 6 x wood screws to attach the shelves and brackets (typ) Bore %"-D(a. hole to insert lamp rod f1 Note: £ ide support (C) is located on side 3 of this pattern section. Slot to receive the sides (typ) \ <0 |
