Creative Woodworks & crafts 2004-03, страница 13

Step 3. Scroll along the outside line of caribou pattern first. This line is marked "outer perimeter of backer board" on the full-size pattern. The plywood overlay and backer board will now be separated.

Step 4. Drill blade entry holes in the caribou overlay and make all inside cuts. Note: do not cut out weather combo insert hole at this time.

Step 5. Now scroll saw along the perimeter pattern line of the caribou overlay and make center punch mark for weather station insert.

Step 6. Remove caribou overlay pattern from 1/4" plywood and lightly sand. Then stain the caribou overlay with Golden Oak and stain 3/4" backer board with Dark Walnut. Set aside to dry.

Step 7. Temporarily attach base patterns to wood.

Step 8. Cut out top and bottom bases at 22°, then drill the four pilot holes through the top base where indicated on pattern.

Step 9. Center the top base over the bottom base. Using a small drill bit and the two outer holes of the top base as guides, mark two holes on the bottom base. Next, drill the pilot holes through the bottom base where just marked.

Step 10. Working from the bottom side of both bases, countersink the two inside holes on top base and the two holes on bottom base. continued on page 14

14 • Creative Woodworks S. Crafts March 2004