Creative Woodworks & crafts 2004-04, страница 22
iESsSBBSiiS fii Some prefer lo place a small drop of hot glue or woodworker's glue in the waste area between the pieces. When using woodworker's glue, however, you need to be very sure that all of the gluing is done in the waste areas, because this type of glue forms a permanent bond. 16 • Creative Woodworks 8. Crafts April 2004 S>cr9 Wood so good you won't want to cut it!\\ -» This "Baltic Birch" plywood is the - ultimate plywood for scrolKvork or fret work. All the pties are birch, with no inner voids so the edges finish beautifully. Our ScrolkPLY is always clear and perfect on one face, though the back may have an occasional plug. Just call for special sizes!
■0\\sM oou - These are the solid hardwood blanks that have the scroll world talking! Each blank is a clear cotor matched panel, sanded to thickness. Spend your time scrolling instead of trying to glue and plane wide panels yourself!! Just apply your pattern and start scrolling.
Note: Sincemostofourproductsarecus-tom made and very popular, there maybe a production lead time before your order is shipped, please inquire at time of order. go! wood? Note: Sincemostofourproductsarecus-tom made and very popular, there maybe a production lead time before your order is shipped, please inquire at time of order. insured Freight Charges Continental U.S. Addresses Order Value: $0-$20.00, add $5.95 Order Value: $20.01-$50.00, add $7.95 Order Value: $50.01-$100.00,add $9.95 Order Value Over $100.00, add $10.95 Alaska, Hawaii, Puerto Rico, Canada, and other International Heritage Building Specialties win incur additional 205 N. Cascade freight charges. Call for quote Fergus Falls, MN 56537-2208_ 3" CO CD Another way lo glue a stack together is lo spray glue both sides of a piece of paper (like yon would a pattern), and then place this between the pieces of wood to form the stack. The problem I have with any of the gluing methods covered above is that the glue needs time to set up before you can start, cutting. Conclusion There is no right or wrong way to make a slack. Any of the methods touched upon in this article will work, but some are easier to execute than others. I suggest that you try a few of the methods shown to find Ihe one you like best. Keep in mind that il is important that the stack does not shift while you are cutting. You might also want to try different stack thicknesses in order to match your style of cutting. Stack culling can save you a lot of time when culling multiples of a project. Give it a try! |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
