Creative Woodworks & crafts 2004-04, страница 56

Step 8. Drill the holes for the cord and pen holders with the correct drill bits: an 1/8" drill bit where indicated on the pattern for the business card holder, and an 11/64" hole for the pen holder.

Step 9. Turn the

piece over and countersink the holes to the appropriate depth in order to accommodate the screw length.

Step 11. To give the piece a more elegant look, round over the bottom edge just a little with a router and a roundover bit.

Step 12. If you are

using wood, sand the piece to at least 800-grit. Sand the Corian piece using the padded aluminum sanding discs to 12,000-grit. The Corian piece is finished and is now ready to accept the pen and business card holder.

Step 13. Apply small rubber door bumpers to the bottom of piece and, as always, sign and date your work.

Step 10. Using a router with an ogee bit, rout the top of the material.

16 • Creative Woodworks 8. Crafts April 2004

Step 14. Screw the business card holder and the pen holder in place and "Voila"—you are finished.

For questions concerning this project, send an SASE to: Barry Gross, 2)89 Philip Drive, Bensalem, PA 19020. Email: 2bgross@prodigy.net