Creative Woodworks & crafts 2004-08, страница 85

Edge view (C)

Wrap with twine

Lower roof panels (C) - make two from 3/8" material

Middle roof panels (D) - make two from 3/5" material

Fence boards (L) - make six from 1/6" material

Metric Conversions:

11nch - 25,4mm = 2.54cm = 0.0254m Common Measurements;

1/16" = 1.59mm 1/6" = 3.15mm 1/4" = 6.35mm 3/8" « 9.53mm 1/2" = 1.27cm 5/6" = 1.59cm 3/4" = 1.91cm 7/8" = 2.22cm 1" = 2.54cm 2" = 5.06cm 3" = 7.62cm 4" = 10.16cm

5" = 12.70cm 6" = 15.24cm ?' = 17.78cm 6" = 20.32cm 9" = 22.86cm 10" = 25.40cm 11" = 27.94cm 12" = 30.48cm 24" = 60.96c m 36" = 91.44cm 46" = 1.14m 60" = 1,52m

Top roof panels (E)

- make two from 3/8" material

Cut out this opening

Upright (B) - make from 3/4" material

Trim layout

FULL SIZE PATTERN SECTION NO. 1 AUGUST 2004

Open door (F) - for trim see separate pattern

Siding strips (M) - make from 1/8" material

Open door (F) - make from 1/4" material

Poor trim (K) - make from 1/8" material

Trim for open door only (see trim layout pattern for sizing on rest of trim)

Hay bale (J) - make from 3/4" material

Bevel ends as shown

Bevel end as shown

Edge view (D)

Edge view (E)

Full Size Pattern Coyote Candleholcb srs from page 20

Weather vane (I) - make from 3/16" material

Rsttems for trim pieces shown In actual positions (except for trim on open door)

Doortrlm (K) - make from 1/8" material

Full Size Rat-terns Miniature Horse Barn from page 12

Not*;: all of the designs In Creative Woodworks & Crafts pattern secti?n6 are copyrighted. You are permitted to make photocopies ONLY for your personal use. You may give away or sell the completed projects you make from them, but you are NOT permtted to make copies of the actual patterns themselves to sell, give away or otherwise distribute In any other form.

Fence posts (H) - make four from 3/8"-Pia. hardwood dowel

End view (J)

Side view (J)

Bone 1/8"-Pla. hole for mounting screw (countersink on back side)

Round overtops to resemble real posts

3-3/8'

Door Insert (G) ■ make from 1/4" material Use a 1-13/16" Foretner bit to bore mounting hole for clock Insert, or carefully cut on a scroll saw