Popular Woodworking 2002-08 № 129, страница 49

umn. I trimmed a long taper on the top of each to make it a little more aesthetically pleasing.

When you drill the clearance holes for the screws, pay attention to where the screws are located, or you'll end up drilling into another screw. Offset them slightly and you'll be fine.

With the feet attached, I added four adjustable leveler feet to make sure the stand would sit solidly on my uneven garage floor.

Torsion-box Top

I wanted to make the top of the stand as lightweight and strong as possible, but still stable. To accomplish this I used ¹/2"-thick Baltic birch plywood and built an open-front torsion box.

Before making the box, locate the center position on the bottom plywood piece and mark where the top of the post will meet the box. Then screw two 1/4" x 1³/4" x 5" solid-wood blocks to the underside of the plywood, centered and on either side of the post's location. Use these two mounting blocks to attach the table to the post after you have completed the table.

To form the box, simply assemble it with a brad nailer, making sure to align all the edges to keep things square. The two tops are held flush to the outside ends, leaving a 3"-wide gap in the center to allow plenty of room for a circular saw or jigsaw blade. The space in "the valley" ends up at a 2¹/2" depth, which should allow clearance for almost any jigsaw blade and lots of room for the blade of a circular saw.

With the table frame complete, nail h" x 2" x 4¹/2" backs into the spaces at the rear of the box, closing up the opening. The hardwood fence is next. Drill four clearance holes and screw the fence to the back of the box, screwing into the backs.

The feet are attached to the column with flat-head screws (top). Watch the screw alignment or you'll drill into another screw. Some simple hardware from your local home center store allows you to lock the post solidly, but quickly loosen the post and readjust for any height.The hardware is shown at right, resting on top of the column before being attached through the holes.

To avoid any concern of binding a saw blade during the first few uses, cut a notch in the fence 1" wide and as deep as the blade depth you're most likely to use.

You're now ready to attach the table to the base. Drill clearance holes in the center of the mounting blocks under the table, then screw the table to the post.

A Little Something Extra

The roller is really inexpensive, and is quick to put together and attach. Simply drill two ^1/4" clearance holes in the 1¹/8" x 2" x 9¹/2" roller block, from each end,

and centered on the block. Use a ^"-diameter drill bit to countersink the top of the holes to fit the head of a machine bolt and a locking washer. Then flip the block over and use a Forstner bit to countersink the bottom of the hole to accept a hex nut.

Before attaching the hardware, place the block in the table valley and use a pencil to mark the hole locations on the table bottom. Then drill oversized V4" holes at those locations.

With the bolts inserted and tightened down, screw the roller mounting brackets in place on

the block. The ends of the bolts will slide easily into the holes in the table, and the roller can then be attached using two wing nuts. When the roller isn't needed, it fits snugly inside any one of the open-end spaces in the table.

No matter where you use this stand, you'll find rough-cutting lumber a more pleasant experience. I'm pretty sure there are a few other uses for this stand as well. Just give me some time. PW

This shot shows the partially assembled table, with three exposed dividers and the other side covered with the top.You can also see the screws through the bottom that hold the mounting blocks in place.While the box itself is nailed together, the fence is attached with screws to allow for replacement if it gets cut up too much in use.

48

Popular Woodworking August 2002