92, страница 33
mO x 2" Fh WOODSCREW CUTTER ARM (see pattern) ROLLER BAR (1 x site) CUTTER ARM NOTE: sanp 1W-WIDEFLAT — for cutter bar (see close up) Pattern (3%nxsv blank) < Easy Rip. The pivoting arms of the paper cutter allow the angle to rest against the paper roll. This makes it easy to tear off just the amount of paper you need Roller Setup. The paper roller slides into wide dadoes and rests in notches. The angle iron provides a straight edge for ripping off sheets of paper crr-cvirtrnents sere specific ;> to size Jd nt a box of =£5. then you cr-*r\partment L'W'rfs. are top shelf, you - the right face compartment. 2nd screw the I turned my peg rail. To keep they're set at a Ic 1 made the .rriti press with a - ting the table, pegs more strength, r>y the back of the -rst attach the rail sn. using the holes r— je, drill through angle. Glue will the holes. HKR CUnER - to make and add si. It consists of an reached to pivoting it sitting firmly - U t «r easier ripping. :js± pivoting arm is -a d pieces of V ply-rogether, as Figure 3 iTt - uble-U-iickness of the arms will prevent the cutter from twisting as you rip the paper off the roll. When the glue dries, you can use the pattern drawing above and your band saw to cut the arms to their final size and shape. The next step is to install the arms (Figure 3a). But don't tighten them down completely — they need to swing easily when you replace the roll and as the mil gets smaller. Angle Iron. With the arms in place, you can cut the angle iron lo length that serves as the paper cutter. After filing the ends smooth, go ahead and attach it to the arms. Wall Installation. With the cutter installed, the cleanup station is ready to be hung on your shop wall. Remember, the cabinet itself is heavy and will be that much heavier once you slip the roll of kraft paper on it, so make sure you hang it securely. Now, all that's left to do is chase down the cleaning supplies in your shop and corral them into your new cleanup station. & NOTE: roll of kraft paper is 30* wide (sources. pg. 51) FIGURE NOTE: cutter arm is made from two layers ok ■v plywood CUTTER BAR fife" x life* - SOV' angle (ron) K-ShopNotes.com 33 |
