Woodworker's Journal 1981-5-1, страница 16

The Gift Shop (cont'd)

Hand Mirror

With pleasing lines and a gracefully curved handle, this stylish mahogany hand mirror will make a most attractive

Start with good flat V." stock, about 15" long and at least 7'/i" wide. Using the grid pattern, lay out and mark the entire profile as shown, then locate and mark the center point of the glass cutout circle. At this center point, drill a '/.■ dia. x '/. deep hole for gluing a '/•" dia. x Vi" long dowel pin. This pin will serve as a bearing point for the router to cut a perfect circle.

Use a Vt" dia. straight bit in the router and set for a depth of 3/16" - '/<". We used a Sears router with a base diameter * V/i" diameter circle. If your

twist the first piece, end grain

piece, end grain up. with a clockwise rotation. Continue —itil all picces are end grain up and matched.

Glue with Elmer's Glue-All. When dry, even edges, then add end grain frame. When frame dries, belt sand surfaces flush. Further sand by hand, ending with 320 grit paper.