Woodworker's Journal Dish-Towel-Holder, страница 3

Dishtowel Holder Step-by-Step Instructions

1. Cut two pieces of 3/4" thick stock to 3-7/8" (allows for saw kerf) wide x 2" long to make the blocks.

2. Face-glue the pieces together, being sure to run the grain in the direction shown.

3. Clamp the pieces together and allow the glue to dry.

4. Locate and drill the two 1/4" dowel pin holes.

5. Use a back saw to cut the block at an angle as shown.

6. Make the front (C).

7. Glue and firmly clamp part A in place at a point 1/2" down from the top and centered across the length.

8. Secure part B to wall with screws.

9. Position part A over part B so that the holes line up.

10. Insert unglued dowel pins.

11. Apply a coat of Deftco Danish Oil to complete the project.

These plans were originally published in Volume 6, Issue 5 of The WoodworkerS Journal (Sept./Oct. 1982, page 41).