Woodworker's Journal Writing-Desk, страница 7

53. Clamp an edge guide to part N to begin making the two 3/8" deep x 3/8" wide stopped dadoes in part N to take the shelves (P).

54. Equip the router with a 3/8" diameter straight bit set to make a 1/8" deep cut.

55. Hold the router against the edge guide and cut a 7-1/2" long stopped groove (see drawing).

56. Make two more passes, with each one making a 1/8" deep cut, to complete dado.

57. Transfer the profiles for parts N and O from the drawing grid pattern to the stock.

58. Use a band or saber saw and, staying slightly on the waste side, cut out the profiles.

59. Sand the stock to the profile lines.

60. Cut part P to length and width.

61. Cut the tenon on each end of part P as shown.

62. Check for a good fit in the stopped dado and make adjustments as necessary.

63. Cut parts Q to length and width.

64. Final sand parts N, O, P, and Q.

65. Assemble with glue and clamps as shown. NOTE: Part Q is simply a glued butt joint.

66. Cut slotted holes in part G to accommodate the screws that will hold the top in place.

67. Use round headed wood screws with washers driven up through parts G to attach the top (L).

68. Secure parts N to part L with 3/8" dowel pins as shown.

69. Make the drawers according to standard drawer construction techniques.

70. Give the entire project a complete sanding.

71. Apply two coats of polyurethane for a durable final finish.

These plans were originally published in Volume 8, Issue 3 of The Woodworker S Journal (May/June 1984, pages 42-44).