Creative Woodworks & crafts 1999-01, страница 46

continued from page 45

Cutaway View Drawiti0

Gable ornament

Roof panel (typ)

Allow equal overhang on the front and back

■""■m-.i

Back panel

Side panel (typ)

Front panel

-Install the door with small hinges

Door stop

Support block

Rear mounting hole to receive the cord arid socket

Base

-^BHHSraraCBSHRmHHHMHHM^HMMMg^MMN

SCROLL SAWING TIPS F9R CUTTING ORNAMENTS COURTESY OF THE ART FACTORY

Make a photocopy of the pattern to be sawn and save the original pattern for future use. Use a temporary-bond spray adhesive to affix the pattern directly onto the wood. After sawing, pee! away the paper pattern.

Before sawing, drill any holes that may be required, such as eyes, hangers or access

holes through waste areas. Use a backer board while drilling (and for some sawing) to prevent any splintering of the bottom side of the workpiece.

The entire fretwork process is based upon making interior and exterior cuts in a design. For interior cuts, drill holes through the waste areas at convenient locations, thread the scroll saw blade through a hole, reclamp, and make the cutout.

To cut more than one piece at a time, stack