Creative Woodworks & crafts 1999-01, страница 47

supplies

Inside cuts and ail kinds of fretwork will . be easier M with this MM new lever

system! fff||||

cables or ]H

it's as easy as lifting one finger!

Wood: oak or wood of choice*— one piece each, 3/4" x 5" x 9-1/2"; 1/4" x 7-3/4" x 19"; 1/4" x 4" x 9-1/2"; 1/4" x 2-3/4" x 16": Baltic birch plywood*— one piece, 1/8" x 4-1/2" x 7-1/4"

Tools: scroll saw with No. 7 . double tooth, No. 7 single tooth, and No. 5 reverse tooth blades; drill with bits Temporary-bond spray adhesive White translucent Plexigfas,

1/8" X 4-1/4" x 7"** Two small hinges Nightling cord with switch

and bulb** Wood glue

Clamps or rubber bands Brass escutcheon pin and nail Clips/cleats, or points of choice

(to hold the front panel in place)

Finish of choice

I To order: write or call, Jim Dandy Products, Inc., . I 1695 Boundry Rd., Dept.33, Downers Grove, IL 60516. • Phone: <800) 522-4717 Fax: (630) 969-7698 ' E-mail: jdsales@fimdandy.com Web: www.jimdandy.comi

*Available from Dave Klimchuk/Elegance In Wood; (716) 542-6045, 8258 Maple Rd., Akron, NY 14001.

**.Available from The Art Factory, (800) 566-6394, P.O. Box 701, 950 Hollman St.. Platteville, Wl 53818.

If you do lots of scroll sawing you'll love HANDY TOP!

Here's why:

* Gives you a large, 16" x 24" scroll saw table!

* Fits any scroll saw! (attaches with double-sided tape, which Is provided)

* Made from absolutely flat material (high-impact polystyrene) and will not warp!

* It is reversible!

* Provides a friction-free work surface, and creates a high-contrast, non-glare background!

* Allows you to drill your own size blade hole, and it can be moved to permit unlimited blade hole locations if holes wear!

ATTENTION DEWALT SCROLL SAW OWNERS.

OUR NEW EASY LIFT SYSTEM ALLOWS YOU TO RAISE OR LOWER THE SAW'S UPPER ARM WITH JUST A FINGER TIP AND THE ARM WILL STAY WHEREVER YOU LEAVE IT!

I JUST SI9.95 plus S4.95 shipping & handling

AT LAST, THE PERFECT "ADD-ON" WORK SURFACE FOR EVERY SCROLL SAW! INTRODUCING HANDY TOP!

layers of wood and fasten them together with very thin nails driven through the waste areas.

Hoid the workpiece firmly and do not crowd or hurry the work. Try to keep the blade centered on the pattern line. Strive for sharp corners or points and smooth, even curves.

To order: write or call, Jim Dandy Products, Inc., 1695 Boundry Rd., Dept.33, Downers Grove, IL 60516. ^m\ Phone: (800) 522-4717 Fax: (630) 969-7698 E-mail: jdsales@jimdandy.com Web: www.jimdandy.com