Creative Woodworks & crafts 2000-08, страница 12

INSTRUCTIONS

Attach the pattern to the wood using spray adhesive, drill blade entry holes, and make all cuts. Remove pattern and sand as needed.

Next, working in sections, glue plastic wrap to the back of the design. Be sure that the plastic wrap makes a complete seal around the bottom surface of all cut areas.

Fill areas with just enough Envirotex to cover the bottom surface. For very small areas, use the drip method by dipping a plastic spoon into the Envirotex and drip it into the area. Allow to dry.

Using a disposable brush, paint all remaining exposed surfaces with a thin coat of Envirotex and allow to dry. Next, mix the remaining Envirotex with its accompanying dyes in the colors of your choice and finish filling areas as desired. Be careful not to allow any overflow. Once completely dry, remove plastic wrap and trim any seepage away with a craft knife. If)

SUPPLIES

Wood: walnut or hardwood of choice—one piece

1/4" x 10" x 18-1/2" Tools: scroli saw with assorted biades; drill with bits Temporary-bond spray adhesive Sandpaper, assorted grits White glue Piastic wrap

Envirotex-Lite with dyes of choice* Disposable paintbrush

* A vailable from FEW Products, (503) 342-1614