Creative Woodworks & crafts 2000-08, страница 32

llfiiSfWmmmmm

continued from page 30

yiSyy.^

Step 4. Glue the body and support assembly into the appropriate slots in the base assembly. Apply glue to the front and rear shelves (F and G), then insert them into the lower slots of the body and the support. Clamp in place with a large rubber band and allow to dry.

Step 5. Glue the legs (N and O) in place. Tilt the body and support assembly to get the legs into the correct slots. Once legs are in place, clamp entire assembly tightly with rubber bands and allow to dry.

Step 6. Insert the brace (B) into the center slot at the top of the body. Hold in place with a rubber band looped over the top of the body. Do not glue. Slip oriented rings (H) in place in outside slots of the brace and the support. This can be accomplished by pulling down lightly on the brace. Once the rings are in place, position two ribs (I) oriented perpendicular to the brace and the support. This lines up the rings for easier assembly later.

Step 7. Glue the horizontal trim pieces (E) in place.

Step 8. Glue the remaining ribs in place Do not force these pieces. If necessary

Step 9. If you are using the optional music movement, now is the time to