Creative Woodworks & crafts 2000-08, страница 6

Is H ft* if Bist^ Patterns "Ipl

I I 1 i ^M Fw Located in |p 't L. " Full Size Pattern J||

Section

wens

INSTRUCTIONS

Attach the patterns to the wood using spray adhesive. Drill blade entry holes and begin by cutting along all inside lines, then saw around the perimeter. Bore the hole to accept the clock insert and sand as needed.

Slip the feet supports (D) over the feet, apply glue, and center on the base. Clamp to dry. Note: feet supports should fit snug, but not tight. Be sure to check foot location before cutting, then adjust as necessary. Center the front ring (B) on the front of the body (A) and glue in place. Allow all glue to dry for one hour.

Apply finish of choice according to manufacturer's instructions and allow to dry thoroughly. Insert clock movement and enjoy!

BILL OF MATERIALS

Part Description Size in inches Quantity

Yellow Birch:

A Body 1/2x8-1/2x14 1 Walnut:

B Front ring 1/4x3-1/4x3-1/4 1

C Base 3/4x3x12-5/8 1

D Feet supports 1/8 x 1-1/2 x 3 2

SUPPLIES

Tools: scroll saw with assorted blades; drill with bits

(including a 2-3/8"-Dia. Forstner bit) Temporary-bond spray adhesive Sandpaper, assorted grits 2-3/4-Dia. clock insert* (Part No. 0008CW)* Wood glue Clamps

Oil finish of choice

'Available from Steebar Corp. One clock movement retails for $12.95 (including S&H), two clocks are $21.90 (including S&H). This offer includes a free 100-page Scroll saw/ clock caialog. Call or write P.O. Box 980, WC-31, Andover, 107821-0980; (973) 383-1026.