Creative Woodworks & crafts 2001-08, страница 23

Fig. 1. I use small pneumatic sanding drums to shape my intarsia pieces.

Fig. 4. Be careful that the slot for putting money into the bank does not spread. Put the ear in place and use a spring clamp to keep it from spreading.

Fig. 2. Smooth the pieces with a flap sander.

Fig. 5. Glue the front board onto the bank body.

and inside the hole to build them up for a better fit.

Next, glue on the back board. Finally, glue on the intarsia face as you would usually do. When I had everything glued up, I sanded the bottom of the bank on my belt sander to get a smooth base. Hold the bank tight when you do this.

Use whatever finish you like. I used Minwax Satin Durathane (three coats on the front and one on the back). Sand between coats. M