Creative Woodworks & crafts 2002-09, страница 6

Pattern Located in Full Size Pattern Section No. 1!

by Tracy Walts and sawn by Vernon Brown of The Wooden Teddy Bear, Inc

ispis^

■MtiMi tMmwmmm mmmwmm

^mMSMmm

SUPPLIES

Wood: fight grained hardwood of choice—

one piece l/2"x5"x 12-1/2" Tools: scroll saw with Nos. 3 and 5 reverse tooth or crown tooth blades; drill with bits including a No. 58 and l/8"-Dia. bit Temporary-bond spray adhesive (3M #77) Sandpaper, in fine to extra fine grits Clear polyurethane Strip of leather

INSTRUCTIONS

Copy the pattern, saving the original for future use, and affix it to the selected stock with spray adhesive. When affixing the pattern, apply a light coat of adhesive to the back of the pattern; do not spray the wood. Wait 5 to 10 seconds for the glue to become sticky like tape (too sticky and the pattern will be hard to remove after cutting, not sticky enough and the pattern might start to come off during cutting).

Bore blade entry holes in all areas to be cut out. Make all internal cuts before making the outside cut, as this will give you a much more stable piece of wood with which to work.

Gently sand the piece using fine to extra fine grit sandpaper. The reverse tooth or crown tooth blades should have reduced the amount of sanding needed in the cutouts. Finish the project with clear polyurethane. Bore a l/8"-Dia. hole side to side through the top part of the feather, approximately .1/2" to 1" down from the top. Hang the feather with a strip of leather,

IIH

mmmmmmm

M

i m iMBPi

_{__}__„

11 x i m wmm

mm I * m 111

Mm

PNMMI

§§§§>1!