Creative Woodworks & crafts 2002-11, страница 28

Pattern Located in Full Size Pattern Section No. 2!

ROY ROGERS

by William R. Wilson (A.K.A. trucking 36^:yahoo.con-.j

INSTRUCTIONS

Copy "he pattern and transfer it to the selected stock, attaching it with a light mist of spray adhesive. Bore blade entry holes in the waste areas of the pattern. Hint: drill only a few holes at a time, as this will keep the workpiece level on the table. Starting with the smaller sections first and working toward the larger areas, make all cuts. Note: if you are unfamiliar with the spiral blades, practice on a piece of scrap wood until you get the feel for it.

Sand the back of the piece with 220 grit abrasive paper. Use the mineral spirits to remove the pattern then sand the front with 320 grit abrasive paper.

Spray adhesive to the back of the silhouette and adhere the fabric to the back. Cut off any exces.§ with scissors, u* -.

SUPPLIES

Wood: Baltic birch plywood or wood of

choice—one piece 1/4" x 8" x 11" Tools: scroll saw with No. 0 spiral blades;

drill with bits; scissors Temporary-bond spray adhesive Sandpaper, assorted grits (including 220

and 320 grit) Mineral spirits (for removing the pattern) Fabric of choice for backing one piece 10^! x 12"