Creative Woodworks & crafts 2003-03, страница 61

Step 5. After the inside of the pattern is cut, place Hot Stuff Super "T" CA glue on the back of the SSV material, place it on the wax paper, and spread it around. This will evenly spread the glue all over the back of the ornament. Then place the ornament on the acrylic piece and allow it to dry for 30 seconds. Cut around the outside of the glued-up piece as per the pattern.

Step 6. Wet sand the edges of both the SSV and acrylic with 220, 320, 400 & 600 grit wet dry sandpaper followed by the 2"x 2" aluminum oxide sanding pads to obtain a satin smooth finish. This should only take about 5 minutes to complete all the steps!

Step 7. If you have a polishing wheel, first use a white diamond compound on the sun catcher and then buff it with another for a dazzling shiny edge. Bore a 1/16" hole in the top of your sun catcher and feed a piece of thread through to hold your work.

ARTISAN SCROLL SAW BLADES

ORDER DIRECT FROM "MR. SOLID SURFACE": M FINALLY ONE SCROLL SAW BLADE THAT EASILY MAKES DUST OF... HARDWOODS, CORIAN® & ACRYLICS WITH EASE! Win the war against sanding and obtain a satin smooth cut for all your Hardwood, Corian and Acrylic needs using the imported skip tooth blades listed below. All Artisan scroll saw blades are $6.95 per dozen, plus $1.50 shipping &handling per order. Visa & MasterCard accepted.

New Assortment Package - Contains 2 each of every blade Hsted above, a total of 18 blades for only $9.95

For a complete listing of all Artisan products visit our website at:

www.bgartforms.com or call 888-717-4202

BG Artforms, 2189 Philip Dr., Bensalem, PA 19020

fhermoformed (heated and shaped) and will polish to a gloss shine. It is available in any size and three colors from BG Artforms, For information on SSV look on the BG Artforms website www.bgartforms.com or call 888-717-4202.

61