Creative Woodworks & crafts 2003-06, страница 26
SUPPLIES Corian9 in color of choice—one piece 1 /4" x 4-1/16" X 5-1/8" (for the back), one piece 1/4" x 4-1/16" x 1 -3/8" (for the front), one piece 1 /4" x 4-1 /16" x 1 -3/8" (for the bottom), two pieces 1 /4" x 1-3/8" x 1-7/8" (for the sides) Tools: scroll saw with No. 4 Artisan blade*: drill with 1/16"-Dia. bit or smaller; router or pneumatic sander*; polishing wheel with muslin wheel and a good polishing compound (optional); random orbital sander (optional);clamps; hone 3M Spray Mount"'' Artist's Adhesive Wet/dry sandpaper, assorted grits (including 220, 320, 400, and 600) 2" x 2" aluminum oxide sanding pads'' Black InLace and clear Mace with blue metal flake* Denatured alcohol Wax paper Masking or packing tape Hot Stuff Super "T" Cyanoacrylate glue* (CA glue) [Note: this brand represents a medium viscosity and is recommended because it will bond in approximately 15 to 30 seconds,] * Available from BG Artforms, 2189 Philip Drive, Bensalem, PA 19020; (888) 717-4202; or visit their website at www.bgarfforms.com. InLace is available in two separate specially designed Scroll Saw kits with 4 different colors in each kit. These kits are exclusively offered through BG Artforms for $39.95. A solid surface aluminum oxide sanding kit [CSK-3] is also available tor $ 15.95. Photos and descriptions of these sanding products con be found on BG Artforms' website. 34 • Creative Woodworks S, Crafts June 2003 Corian Business Card Holderl by Barry Gross, Mr. Solid Surface of BG Arfforms INTRODUCTION I have received many requests for business card holders made from Corian'*. To answer this demand, Mr. Solid Surface has come up with the following project. You can use any logo you wish for the top part of the design. I chose the one pictured because my dive shop happened to be one of the many businesses requesting a card holder. INSTRUCTIONS Step 3. Place the front piece and the bottom piece on a sheet of wax paper and glue them together using the Hot Stuff Super "T" CA glue and clamps. Allow this section to dry for 5 minutes. continued on page 28 Step 2. Note that the back of the Corian* has writing on the surface. This must be wiped off with acetone or denatured alcohol. Step 1. Cut the 1/4" Corian* according to the measurements provided for all the pieces needed. |
