Creative Woodworks & crafts 2004-04, страница 16

Fig. 7, Cutting out the frame detail.

Proceed to round over the outer edge of the frame (see Fig. 3).

Use a scrap of the backer board material to set the depth of the rabbet bit in the router (see Fig. 4). The bit should be just slightly deeper than the thickness of the backer board.

Drill an entry hole in the center of the ball of yarn and proceed to cut out the detail of the frame using the 2/0 reverse tooth scroll saw blade (see Fig. 7).

continued from page 15

Fig. 6. Here, the frame detail pattern has been reapplied to the lower edge of the frame.

Fig. 3. The frame's inner and outer edge© have now been rounded over.

Fig. 4. Setting the rabbet bit depth.

Rabbet the inner edge of the back side of the frame so it will accept the back board (see Fig. 5).

Reapply the cutout pattern to the bottom of the frame, using the spray adhesive in the same manner as above (see Fig. 6).

Fig. 5. The frame's back inner edge has been rabbeted.

Cut the backer board and the kitten

Using the 2/0 reverse tooth scroll saw blade, cut out the 1/8"-thick backer board by cutting along the oval dotted line as indicated on the pattern.

Using the small drill bit, drill the blade entry holes in the kitten and cut it-out, working on the inside detail cuts first and the outer perimeter last (see Fig. 8).

continued on page 18

Fig. 6. Cuttin' the kitten, inside cuts first.

16 • Creative Woodworks 8. Crafts April 2004