Creative Woodworks & crafts 2004-04, страница 15
mm mm IHi lilMIIMil II wsm SUPPLIES Wood: cherry—one piece 7-1/2" x 9 ' x 1/2" thick (for the frame); birch plywood—one oiece 6" x 8" x 1/8" thick (for the backer boarc); maple nardwood—one piece 5" x 7" x 1 /8" thick (for the Kitten) Tools: scrol. saw; reverse tooth scroll saw b.'ades Nos. 2/0 and 5: drill or driU press with 1/16" bit; route1- with roundover bit (for edging of frame) and rabbet bit Temporary spray adhesive Clear drying wood glue Point in desired color (for backer board) Spray varnish in the finish of your choice Sawtooth hanger INSTRUCTIONS Make the frame Make photocopies of the original patterns and keep them for future reference. Make several copies of the pattern and cut apart for the different aspects of the design. Apply a light mist of temporary spray glue adhesive to the patlern pieces and wait a few seconds for it to "tack up" (it should have the same fee: os masking tape). Apply the pattern pieces to the cherry, maple and birch pieces respectively. Drill an entry hole in the waste area of the frame. Thread pjg 2. Round the No. 5 reverse tooth olade through the entry hole and inner edge of scroll out the inner (oval) edge of the frame. the frame f,re\_ Scrol. out the outer edge of the frame using the same blade (see Fig. 1). Place the roundover bit into the router end round over continued on page 16 Fig. 1. Cutting the outer edge of the frame. the inner edge o~ the Irame (see Fig. 2). 1 Will not leave "chatter marks,' as hard-rubber sanders do. 1 infiator is calibrated to give you precise, consistent pressure during each use. 1 You can adjust the pressure without removing the sander from the flexshaft or power sander. How it works - Sander comes with infiator and three sleeves, 80, 120, and 220 grits. Can be powered with a flex shaft in a drill press, a power carver, or attached to a 3450 RPM motor. It can also be mounted to a stationary hand drill. Replacement sleeves S4.95/Pack of 3 VISIT US ON THE WEB SAND ALL FLEX SANDER PLAN A useful tool for detail sanding. The bow part allows for even shaping and sanding of contoured surfaces. Plan includes patterns and instructions to make 2 sanders (large & small). sanding SPECTACULAR WOOD COMBO REPLACEMENT GRITS PACK available in 80,120, 240 grit packs A perfect hand-sanding tool. It's flexible material makes it a great way to sand flat and curved surfaces. Quick and easy hook and loop fastener for replacing grits. SANDSTORM™ INFLATABLE DRUM SANDER Ideal for sanding contoured or irregulariy-shaped objects, such as intarsia or carving. Sanding sleeves run on an adjustable cushion of air. • Fits all power carvers with 1/4" collets, including Foredom and Dremel. • Rated to run up to 5000 RPM. |
