Creative Woodworks & crafts 2004-06, страница 24

continued from page 23

Step 10. Center the tree on the right side of the base and mark the position of the anchors.

Step 11. Use the 3/16" drill bit to drill the two holes in the base to accept the machine screws.

Step 12. From the underside of the base, use the countersink bit to drill two countersink holes.

24 • Creative Woodwork?; & Crafts June 2004

Step 13. Use the router and your selected bit to rout a decorative edge on the top of the base.

Step 14. Use the 5/32" drill bit to drill a hole into the top of the tree where indicated on the pattern for accepting the hook.

Step 15. Varnish all pieces using spray or brush on varnish in your choice of finish.

Step 16. Apply a small dot of glue into the hole and then screw the hook into the tree.

Step 17. Attach the tree to the base with the machine screws.

Step 18. Apply the felt pads or vinyl bumpers to the bottom of the base.

Step 19. Glue the decorative monkey into place. Enjoy!!!

For questions concerning this project contact Sheila Bergner, (708) 532-5624. Email: Scrollgirl@comcast.net ji