Creative Woodworks & crafts 2004-11, страница 38
Pattern Located in Full Size Pattern Section No. 2! INSTRUCTIONS Step 1. Make one copy of the main pattern and two of the smaller pattern. Step 2. Using spray adhesive, put the main pattern on your wood of choice. Step 3. With the No. 58 oil, drill for all Insice cu+s. Use the No. 5 blado to cut, and keep all the larger scraps for inlay lesling. Step 4. With a No. 2 blade installed, angle your saw table 15° to the right. Moving counterclockwise, cut a circle from a piece of saved scrap wood. (Note: if your saw table is tilled to the left, make your cut in a clockwise direction.) Tne circle will drop into Ihe surrounding wood, leaving a slight indentation. Keep increasing the angle and cutting circles until the difference is just enough to allow a piece of shell laminate, ses 'n the indentation, to sit flush with the surrounding area. (If the laminale sils too high at the time of finishing, nothing can be done; if it sits low, paper can be used as shims to bring it flush.) Step 5. Hold rhe small pcttern in place on the project. 38 • Creative Woodworks S. Crafts November 2004 |
