Creative Woodworks & crafts 2005-04, страница 39

I SUPPLIES |

Wood: any three contrasting woods {paddauch, walnut and maple were used Tor models)—c.ssorled I /8"- lo 3/16"~lhick scrap pieces of all Ihree woods (largesl piece needed measures 6-1/2" x 3-5/8") Tocls: scroll saw; drill press with small drill bit Temporary-bond spray adhesive Sandpaper—various grits Small file Xacto knife

1/16" Dia. coppor wire-one piece, 10" long

Wood glue

Oil finish of choice

Introduction

One Saturday, Dan came over lo work in Ihe shop. Since we didn' t have anything pressing lo do, we decided to clean oul Ihe scrap box, and here are Dan's results!

INSTRUCTIONS

We used 1/8"- to 3/16"-thick wood pieces for the trinkets. As you can see, we just cut out several of the same designs in different sizes and layered them on top cf each other, but you can use your imagination and come up with many ether little fun projects. The wood types identified with the pattern pieces indiccte the wood color. Wood I being the lightest, and Wood III being the darkest. Feel fiee lo vary Ihe lype and coloi of wood as desired. Jusl iel your cieativity lake over. The patterns can be enlarged or redcced in size, or even used on other designs. The main objective is to just have some fun! We hope you erjcy these trinkets as much cswe did.

When assembling the flying doves, if is necesscr/ to first drill a 1/16" dia. hole 1/4" deep into the bottom edge of each dove. Cut the copper wire into three assorted si7ed pieces, then insert each one into c hole and glue in place. Drill three more holes 1 /2" deep into the top rounded edge of the large dove rock. Inser' the other end of each cop-perwire into a hole and glue in picce.

for questions concerning this project, send on SASE to: Wilckens Woodworking, P.O. Box 52096, Independence, MO 64052. Err.ait: witksvsood®aot.com!ii

[IrmtiVF Wnnriwnrks fi (Irafls April 2(1(15 • 33

i

Pattern Located in Full Size Pattern Section No. 2!

by Can and Ray Wilckens