Creative Woodworks & crafts 2005-06, страница 53

SUPPLIES

Wood: map.'e burl or wood ol choice- -one p-ccc approximately 3/4" x 14" x 11"*; birch plywood—one piece I /4' x 14" x 11" (for backer}*

Tools: scroll saw with assorted blades; hand

drill or drill press with No. <60 drill bit Temporary-bond spray adhesive Sandpaper (220-grit) Clear packing jape Wood glue Black spray pain!

Finish of choice Hanger of choice

*'ihe dimensions listed here refer to the size of the pattern prov/ded. The size of the original protect as pictured was 3/4" x 29" x 26". This protect could be made from I /4"-thick birch plywood if desired; however, the setting for Ihe angle of the table when cutting the hooves would have to be adjusted. Feel free to adapt the pattern to your wood.

£ i

Fig. 1. Several phvtvb showing the blade-entry Holes being drilled.

continued on page 54 Crcstivc Wocrk.orks 6. Crafts Jint; PflClfi • 53

INSTRUCTIONS

Sand the wood using 220 grit sandpaper. Using temporary-bond spray adhesive, epply the pattern directly to the wood. Use clear packing tape to rover Ihe entire pattern. This helps lubricate the blade durirg cuffing, and it makes the pattern easier to peel off once you ore finished cutting.

Drill blade-entry holes for all inside cuts (see Fig. 1).