Woodworker's Journal 1985-9-6, страница 20

Woodworking Basics

When you have to build a number of cabinct doors, fast, nothing beats a matched set of cutters, usually called a cope/stick or stile and rail culler set. Traditionally, this job was done 011 a shaper hut the trouble was that it required a lot of sel up. A typical panel door sel consisted of five or more special cullers that had in be assembled on the shaper spindle. Numerous irial cuts were necessary and often the spacing between the cuttcrs had to be increased with paper shims so the tongue made with ihe cope sel matched ihe groove made by ihe stick set. For one or two doors. I could hand-chop mortise and tenons and plane the groove fasler than the time required to set up a shaper.

Enter stage right, cope/stick sels for router tables. What a joy. because much of the labor and guesswork is gone and setup is minutes instead of hours. I am

thankful, though, for all of those hours I spent struggling with ihe shaper. They taught me a number of tricks to produce professional results. Fortunately, these tactics carr> over to the router table.

A Little History

The terms slick and cope date from the days of hand-tool joinery. Understanding how the\ came aboui will help us to better understand ihe machine equivalent. In hand-iool joinery. 10 stick a molding is to clamp a suitable plank dow n on the bench and plane a molding shape on the edge. Such work is, of course, done with the grain and the finished molding is then rip-sawn from the wider board. The job was done in this way because it was easier to hold a wide board in ihe bench dogs than to hold a small molding.

Later, when machines replaced hand tools, the term sticking carried forward.

Using a shaper 10 mill a profile on square or rectangular boards was referred It) as sticking or stickermg. When sticking by machine, strips could be ripped to final width first on the table saw and no longer had to be separated from a w ider board after ihe milling operation.

The term cope has a similar hislorj. Most of us are familiar with the task of installing a crown or baseboard molding, and until the early part of this century such moldings were quiie wide. When such a molding meets at an inside or outside corner, cutiing the ends of each piece to a 45-degree angle is fine if ihe room is square. Bui even today it often is not. When faced with such a situation, a traditional workman would simply cut the first piece square to the corner. He would then cope the molding profile in the end of the maling piece. Armed with a coping saw, wood rasps, chisels and a knife he would adjust this profile until

Easy-to-make doors on your router table

bx Ernie Conover

20

The Woodworker's Jtwimal