Woodworker's Journal 2009-33-1, страница 19
RECALL NOTICE ! A recall is in effect involving model number DC608 DeWalt 18-volt Cordless 2" 18-Gauge Straight Brad Nailers with date codes 200728 through 200821. The nailer can operate when the safety is in the locked position or when the trigger is not pulled and the contact trip is depressed. For more information, visit www.DeWalt.com or call 866-220-1481. For edge grain butt joints, glue provides all the muscle necessary. Biscuits help in alignment, but not strength. others. In most cases, you will need to at least hone the bevel and cutting edge because the tool was only roughly ground by the manufacturer. In this case, I'll assume that the profile of the cutting edge and the bevel angle are correct for your needs. In the worst case, the entire cutting edge will need to be reground to change the profile, adjust the angle of the bevel and finely sharpen it. First, use a coarse-grit grinding wheel to reshape the tool, then switch to a fine-grit wheel to smooth the bevel and cutting edge and/or hone the tool's bevel and edge with a wet stone. Some inexpensive turning gouges also have milling marks left inside the flute. These fine lines reduce the sharpness of the tool's edge. Remove them with a curved stone (known as a slip). Take care to avoid rounding over the tool's cutting edge. — Betty Scarpino (Circle No. 39 on PRODUCT INFORMATION form) Continues on page 20... Woodworker's Journal February 2009 (Circle No. 111 on PRODUCT INFORMATION form) 19 For current promotions, complete product Into and a list of dealers near vou: msMsttmsifiuis CAN Bf CUT TD SIZE 0MRIIIREC1IQNM1 NflVlMfNT • 18Bx 24" Model #10-824. will lift up to 600 LBS CUSTOMUABLi May be cut to fit almost «ny size exactly. EFfOimSS MOTION Heavy objects move freely on a cushion of air. IER0 ROLLBACK Stays exactly where parked HIQUIREMINIS Standard compressed air and a smooth floor. |
