Creative Woodworks & crafts 1998-03, страница 52

Fig. 2. The front assembly.

Front assembly detail

Glue the stop to the front {see detail)

Rubber bands

Fig. 3. Assemble the carcass.

Glue the rear assembly to the bottom (see detail)

Glue the front assembly to the bottom (see detail)

Rear assembly/bottom detail | Jig No. 2

Bottom

End view

- Rear assembly

Front assembly/bottom detail

4„

Front assembly |

Jig No. 2

? t

Bottom

Fig. 4. Attaching the sides.

Make sure that the back edge of each side is flush with the brace

Drawing No. 1—the jigs.

Affix the 1-1/2" stock to the 3/4" stock

Side A

The front edge of each side should be slightly proud

Side view

Jig No. 1 Note: the length of jig No. 1 should be 1/2" less than the width of the project.

I-—2-1/4" - [T 3/16"

squeeze out with a damp cloth. Sand all of the back pieces flush, taking care not to oversarid.

Finishing

Apply oi) finish of choice following the manufacturer's instructions and allow to dry thoroughly.

Cut out some poster board to the approximate size of the scrolled openings {refer to the photograph). Cover the poster board with felt, affixing it with spray adhesive. Trim the felt covered pieces to fit, dab a few spots of glue onto the interior surfaces of the wood, and set the felt in place.

Attach the stand securely to the wall or rest it on a flat surface, and install your phone and accessories. You now have something beautiful to look at while you're waiting for that important call! jg>

PHONE & ACCESSORY STAND COMPLETE WOOD PACKAGE! Includes all the top-quality Walnut needed to make this wonderful project. Order Item No. PAS97 Price: $18.95/prepaid. East of

Mississippi, or $ 19.95/prepaid, West of Mississippi. PA residents add 6% sales tax Write to: Croffwood Mills, RD#1, Box 14, Driftwood, PA 15832. or call (814) 546-2532

FREE CATALOG WITH ORDER