Creative Woodworks & crafts 2000-08, страница 49
by Dan and Raymond Wilckens August, 2000 Patterns For Both Clocks are Located in Full Size Pattern Section . No. 2! INSTRUCTIONS Attach the pattern to the wood using spray adhesive. Drill blade entry holes and make all inside cuts, then saw around the perimeter ot the upright. Tilt your saw as indicated on the pattern, then cut along the outside of the base. Bore a 1-3/8"-Dia. hole in the upright as indicated on the pattern and sand as needed. Apply glue to the bottom edge of the upright and center on the base. Secure with clamps to dry. Apply finish of choice and allow to dry thoroughly. Insert mini clock movement according to manufacturers instructions and enjoy! £jrj SUPPLIES Wood: Walnut—one piece 1/2" x 6-1/2" x 6-1/2" (for the upright) one piece 1/2" x 2-1/2" x 7" (for the base) Tools: scroll saw with assorted blades; drill with bits (including a 1 -3/8"-Dia. Forstner bit) Temporary-bond spray adhesive Sandpaper, assorted grits Wood glue Clamps Finish of choice 1-7/16"-Dia. mini clock insert |
