Creative Woodworks & crafts 2003-04, страница 32
_ -.'Patterns Located in Full Size j ^ Pattern Section No. 1! Box: Woodworking INSTRUCTIONS First, copy the pattern (so you have the original for later use). Then, select the wood you want to use. Cut the wood to the proper size to fit the patterns. All straight edged pieces should be cut to size on a table saw or simi lar. Attach the patterns to the wood with a spray adhesive. With a small drill bit, drill a hole in the wcste area of each cutout. Feed scroll saw blade through the small holes and cut along the lines. For exterior cuts you con cu+ in from the edge or drill a small hole just outside the exterior line. Remove pattern from work-piece by peeling if off. Hint: if it is attached firmly, you can use a ha:r blow dryer to loosen the adhesive. Be careful because some cuts ore very fragile. Sand work pieces with belt sander or handheld sander. Remove any burrs and clean up any cuts with a craff knife or a needle pick. Glue the box sides in between the box fronts/backs (see Fig. 1). The sides should be square and flush with the front/back piece. Glue the box assembly onto the box bottom.. This needs to be centered (see Fig. 2). Glue +he box front/back overlay, centered, onto the front ana the back of the box assembly (see Fig. 3). Glue the box side overlay, centered, onto the sides of the box assembly (see Fig. 4). Glue the cross overlay, centered, onto the cross. Then glue the cross assembly, cen- 32 • Creative Woodworks 8. Crafts April 2CC3 by Don and Raymond Wilckens of Wilckens |
