Creative Woodworks & crafts 2003-04, страница 40

WBBBBm

liaiMMHHMMHP

SUPPLIES

Wood; ash—one piece 3/4" x <S" x 4"; walnut-

one piece 3/4" x 12" x12", maple—orte piece 5 3/4" x 3" x ^:3": oak--one piece 3/4" x 10" x 15": i I plywood—dne piece 3/4* x 15" x 15'¹ (to shim the head}, one piece 114" X i5> x 20" (for the backer board} Toofe: set off saw; F0 rrS blades, osculating spindle sander with assorted grits, drill press with mop wheel 220 grit,' palm sander with assorted grits Wood glue v

Carbon paper ' £ '

Clamps §§|§

Brad nailer (optional) 3§jg|

Hshggr of choice • /

Step 3. Make sure the cuts are sanded at 90 degrees to Step 4. Next, begin cutting out the nose, assure a good fit.

Creative Woodworks S. Crafts April 2003 • 19

by Darin Liles of Shirley, AR

Pattern Located in Full Size Pattern Section No. II

INSTRUCTIONS

......... .... .....KSto'SSS?!?^^

Step 1. Start by Tracing' the nedcT ouf"on Tracing paper; This will allow you to be selective about wood grain during layout. Starting with the center part of the face, saw the piece to shape.

face as a guide for a more accurate cut line.