Creative Woodworks & crafts 2004-03, страница 61

INSTRUCTIONS

Apply pattern using spray adhesive. Wrap entire project in 3 to 4 layers of clear packaging tape.

Drill out designated areas. Drill entry holes. Cut out trivet with saw set at a speed of about 1300 strokes per minute. Cut out trivet feet.

Scrape residue on edges with craft knife. Sand edges as necessary. Round over bottom edges of trivet feet and polish. Position feet on bottom side of trivet and glue in place.

For questions concerning this project, send an SASE to: Joan West 3810 Tarpy Dr. SW, Cedar Rapids, IA 52404.

Patterns Located in Full Size Pattern Section No. 1

Coriair Trivet

14 • Creative Woodworks S. Crafts March 2004