Creative Woodworks & crafts 2005-03, страница 31

g&ZHtt&ff!

Fig. 2. Apply the pattern pieces over the plywood scraps.

Fig. 1. Place two pieces of veneer between two pieces of plywood scraps of the same size.

Fig. 4. Carefully cut out the design detail of the earring,

Fig. 3. Drill entry holes in the design detail waste area

Fig. 6. Press the veneer piece to the oak base piece and use a piece of paper to apply additional even pressure to the veneer.

Fig. 5. Be sure to carefully cover every edge with a thin layer of glue.

Fig. &. Clamp in place until the glue is dry.

continued on page 32 Creative Woodworks' & Crafts March 2005 » 31

Fig. 7. Place a piece of scrap wood over the veneer.