Creative Woodworks & crafts 2005-08, страница 41

I

SUPPLIES

Wood: osh or wood of choice—one piccc 3/4" x 10" x

19"; dowel rod—one piece 5/8"-Dia.x 13" Tools: scroll saw with No. 2 reverse tooth blades; drill press ard assor led bits including 5/8" Forstner bit and I /8" bit with countersink; router or laminate trimmer with decorative bit for edge and keyhole bit: orbital sander end assoited gilts sandpaper (220-600) Clear drying carpenter's glee Spray and Glue temporary adhesive Clear packaging tape No. 8 screws, 1 ,t>" long (two)

Scrcws for hanging project, wilh heeds compctible with

your keyhole router bit (two) Delta interior/exterior varnish in satin finish or varnish cf your choice

Spray varnish in satin finish or finish of your choice

kr^

^uc-..

jM

—"Apply the patterns to wood and press dawn firmly. Be sure g 'to apply the bracket paltern pieces following the grain te direction arrows.

A

(J

h

v

/ ^

VTi \

Kfrace adjacent strips or clear packaging tape over the Ipy^"entire surface of the pattern. This layer of lape will help -i -' prevent burring the wood when cutting it on the scroll ■E&scw. and I highly recommerd it when cutting most hard-^voods.

L

{

INSTRUCTIONS

Preparing and cutting

"•■Photocopy the origiral patterns and keep them for future Ji-reference. Lightly sand the surface of the wood and ccre-fully remove all the dust and debris before cutting. This will _;help to minimize the amount of sending you rnay need to |f'' do after the design is cut. Cut out the pattern pieces and iightly mist the backs with temporary spray adhesive, allowing them to tack up slightly until Ihoy feel like the back cf ■..masking tape.

Drill entry holes in the waste areas of the design using the. 1/8" drill bit. Use a piece of scrap wood underneath to ! help prevent tear-out in the back, although some tear-out -? may occur even with taking this precaution. Before proceeding to the scroll saw, lightly sard Ihe back of the pro- j ject in the direction of the wood grair to ensure that the | wood will sit perfectly flat on your scroll saw table and will: not "cctch" as you are sawing.

\ (

Use the No. 2 reverse tooth scroll saw blade to scroll cut " the towel holder base and the brackels.

Drilling

Mark the exact center of each of the brackets using the • dowel holder mark on the pattern. (Be sure lo mark one"!] side cf each so thct the left side of one bracket is marked and the right side of the other bracket is marked.)

Install the Forsmer bit in your drill press and sot the depth of'

your drill to approximately three quarters of the way

through the wood. ..

^M continued vn page 42

Creative Woodtyarte & Craffs August 2005 • 4V