Popular Woodworking 2000-12 № 119, страница 7
For that "SPECIAL project FREE COLOR CATALOGUE Kits Ready to Assemble & Finish s^ciam c^/wd l.t.d., P.O Box 728, Dept. PW3 Morristown TN 37815-0728 Phone (423) 587-2942^Fax 423586-2188 Circle #100 on Resource Directory Coupon The widest range of woodworking f "A prodUCts anywhere. It's all at rockler.com Rockier Bandsaw Table and Fence,#24504. ROCKLER® WOODWORKING AND HARDWARE Circle #149 on Resource Directory Coupon FREE!woodworking catalog Go to rocMw.umWQIt and order your FREE catalog ^ today! Or call I-8M-403-973* Check out our complete exclusive line of jigs and shop tables for your band saw, drill press and router. PLUS thousands of other great products! ROCKLER® WOODWORKING AND HARDWARE The NEW name for.. 1-800-403-9736 1-877-ROCKLER www.rockler.com Circle #112 on Resource Directory Coupon Circle #150 on Resource Directory Coupon Letters continued from page 8 if the motor gets hot. I have learned to live with it. Another problem is that the band saw blade is 59" long. I have to have them made by special order. I have found a place locally that will make them for about $10 each. The blade diameter for the circular saw is 8". When you convert all this to metric, you can see the sizes would be normal in Europe. All in all, it has been a good piece of equipment, and I can store it in the corner of my shop (garage) without much problem. Thanks again for an informative article. Jim Tabb via the Internet Thicknessing Lumber Can Be Confusing for Beginners When reading the article on the Morris Chair (issue # 115, June 2000) I was concerned because the plans do not discuss planing the wood down to the dressed dimensions. If a beginner can make this chair they may be confused because getting to the finished thickness is never talked about in the article. Jim Whalen Lynchburg, Virginia Editor's note: Thicknessing lumber can be confusing. And the following cannot be repeated enough: To do it right you need both a planer and a jointer. The jointer makes one face of the board flat, and the planer cuts the opposite face parallel to the first face. Planers alone generally cannot remove warp and twist from a board. And jointers cannot produce a board that has two flat faces that are parallel to each other. To do the work properly, you need both machines. PW CORRECTIONS In the "Folding Plant Stand" article in the August 2000 issue, one of the dimensions on the 3D drawing is wrong. The 8" dimension for the first riser should be 7!/4". In the "Scrapwood Scraper Plane" article in the same issue, the dimension of the side pieces is stated as 12" long.Though this dimension isn't critical, it should be closer to 9". 10 Popular Woodworking December 2000 Code 11502 |
