Popular Woodworking 2007-11 № 165, страница 26
Also see: - Locks • Lighting • "— • Fasteners • Kitchen uiyum^eis • Shelf brackets and much more... Request a hKtt catalog today! Promotion #805 woodworkershardware.com or call 1-800-383-0130 CIRCLE #166 ON FREE INFORMATION CARD. DOMINO See Demonstration Videos @ www.mcfeelys.com/domino Faster than Dowels, Stronger than Biscuits, more gluing area too! Perfect for Edge, Butt, Miter and Complex Joints Oscillating Carbide-tipped bit cuts cleanly and quickly Provides positive alignment and joint strength PO Box 44976 • Madison • WI 53744 Toll Free 1-800-443-7937 or at www.mcfeelys.com CIRCLE #135 ON FREE INFORMATION CARD. --Tricks of the Trade ■- CONTINUED FROM PAGE 22 Router Table Extension Rail I made some half-overlay frame-and-panel doors recently, installing the panel a bit proud of the rails and stiles on the front, which recessed the panel on the back side. This isn't an aesthetic problem, but it does create difficulty when routing the rabbet around the edges to create the half-overlay. The doors were rather large, and at points one of the rails and one of the stiles were completely overhanging the router table's top, causing the door to tip, and spoiling the rabbet cut. What I needed was a larger table top that didn't eat up shop space. As a quick fix, I clamped a long rail to the front edge of my tabletop. That was all I needed to carry a door, keeping it level as I routed the edge. And it turns out that the extra support helps when routing all sorts of large panels. If you're not able to clamp a rail to the front edge of your router table, a couple screws would work just as well, and still allow easy removal when the rail isn't needed. — Gabriel Castro, Victorville, California An Overhead Projector Is Useful in the Shop I find an overhead projector to be invaluable when scaling magazine and book plans to full size, especially when the reduced illustration includes curved lines. I begin by scanning the drawing from the magazine, then printing it on transparent media, available at office-supply stores. I tape to the shop wall a large piece of easel pad paper with 1""-square grid lines printed on it, then move the projector forward or backward until the design lays out to the desired finished size on the grid. The easel paper can then be cut out and glued to the wood stock to establish cutlines. The technique also works great for creating carved or painted signs. You can create the text on your computer, then project it to whatever size you like. Of course, using an overhead projector in this manner this isn't new. What is new is the easy availability of affordable used projectors these days on the Internet. A quick search of "overhead projectors" on eBay recently yielded about 200 offers, with lots of them costing less than $50. As far as I'm concerned, that's pretty low overhead for such a time saver. PW — Allen Hyman, Lake Placid, Florida 24 ■ Popular Woodworking November 2007 |
