Woodworker's Journal 101-Projects-for-Woodworkers, страница 50

fi6-. 3

Post

side

DcoR,

R^ie

FfetJT post

y^A^T

the edges, and counterbore and drill the bottom for a threaded pipe, washer, and nut. Also bore a hole or rout a channel for the lamp cord. Cut the 7"-square lid from Yi" stock and bore a Yi" center hole for the pipe within a %* brass tube. If the lantern is to be used for a candle or candle bulb, a 3"-diameter hole should be cut in the center of the lid. Plane and scrape upper and lower surfaces of the base and lid bottom as flat as you can get them.

Join the glued-up front and rear frames by adding the plastic panels and gluing and clamping the upper and lower side rails in place. The assembled frame is then glued to the base and lid. Run the threaded pipe through the assembly and clamp together with nuts at each end.

The door frame, which should fit with clearance all around, is made of %"-thick stock ripped to %" width. All four parts are rabbeted V, x Yt", as shown in Detail B. then butted and

43