Creative Woodworks & crafts 2002-04, страница 45
Louies Available now in the tool section at; For the Lowe's reai-est you, cali 1-B0Q-44-L0WES Home Improvement Warehouse INSTRUCTIONS iSlSiHilBiilfiWW gefferlhanaT/iirdtfanrf/ Step 1. Cut your stock to length and width. We continued some of the bevel, on the outside face by filling our Scroll saw table and removing selected stock to add more visual interest..;- iissiiiiaiiii ammaamStep 2. After you have cut your stock •to length and width, sand both surfaces to 120 grit, removing any tool marks from previous work. Reno, NV 89511 www.panavise.com LOWE'g® is a registered trademark of the LF Corporation @200t Lowe's Home Centers, Inc. Step 3. If you choose to rout out the back of your piece, you will need to attach an extension to your router base. We used a piece of scrap pine about 24" long, with a hole drilled in '.he center for the bit and two holes for mounting screws. We routed the back 1/2" deep. That way we had enough room for the glass, an acrylic protector, and the fasteners. Use any flat bottom straight bit that you have, just make severaf incrementally deeper passes until'you get to the final depth. 81Bh^^^W^P MM/i ; - it WMmm .^^v^JB Step 4. Apply your pattern with spray adhesive, and bore blade entry holes in the waste areas, Use a 1/16"-Dia. (.0625" or 1.5875 mtp) bit for the larger holes and a No. 58 (.042" o- 1.0668 mm) bit for the smaller ones. Stejj 5. We used Olson No. 2R blades for cutting the design in the denser wood and Olson No. 0 for more Control where the wood was softer. We also found that it was necessary to slow: our blade speed a bit so as not to overcut on turns. __r-^ntiryt igrl nn nana A A |
