Creative Woodworks & crafts 2004-06, страница 46

continued from page 45

Making the lid

Step 9. Apply the rest of the patterns: the backer board pattern to the 1/8" stock; the lid underside to the 1/4" stock; and the mosaic pattern to the stacked stock (from left to right in the photo above).

Step 8. Apply pressure sensitive tape to stack the three 1/4" pieces for the mosaic (upperside) pattern. This tape is the very same tape that we golfers use to re-grip our

Clubs...

WsllsSSf 'MnBSgpaSi

Step 11. Use the No. 3 blade for cutting the mosaic pattern, and the No. 5 blade for the outside line. First, make a few pencil lines on the side to help with alignment when putting the lid together. Then thread the blade through the entry hole and cut out the mosaic pattern, making sure to make tight turns.

Step 10. Drill a blade entry hole in the mosaic stock with a 3/32" drill bit.

Step 12. Number each piece on the Step 13. Separate the border pieces Step 14. Cut out lid underside (on

reverse side (i.e. piece No. 1 will be which were produced by cutting the the inner- and outermost lines only)

piece No. 1 on all stacked pieces). mosaic pattern, and; use the butter- and backer board and glue the two

nut piece as the mosaic border; together. Use approximately six

piece. Round over the inner edge of clamps and allow to dry. the mosaic border piece, making sure the top side in facing down.

4E * Creative Woodworks & Crafts June 2004