39 - Modular Wall Storage , страница 21

FEATURE PROJECT

NOTE:

lay out radius from edge of door

³/4"

radius

C ⁷Ae" MAG. ^v CATC"

-V/z"

Va"G ap

___J

® DOOR

(15V&" x 35%" ³/₄" ply.)

DOOREDGING

(vs'-thick hardwood)

NOTE: hang

doors, then glue on cabinet edging

piano hinge

IV2" x 36" piano hinge

CABINET EDGING

(³/,₆"-thick hardwood)

catches. To keep the doors tightly closed, I added magnetic catches to the top and bottom of .the case and installed strike 'plates in each door, see Fig. 4c.

hanging brackets. Once the cabinet is filled with tools, it's going to be quite heavy. To support this weight, I attached four short hanging brackets to the

back, see Fig. 5 and page 19. These brackets are glued and screwed %" from the top and bottom of the cabinet and tight against the sides, see Fig. 5a.

BINS

To keep small parts organized, I added six pull-out bins at the bottom of the cabinet, see Fig. 6.

Each bin consists of a 'V^'-thick plywood front/back (N) and bottom (0), and a pair of V4'¹ hardboard sides (P), see Fig. 6.

Cutting a half-circle in the front piece is all that's needed as a pull, see Fig. 6a. Then all of the bin parts are assembled with rabbet joints, glue, and brads, see Figs. 6b and 6c.

short hanging bracket (see page 19)

No. 39

ShopNotes

21

BOTTOM

(6³/4" x 43/s" - 3/₄" PLY.)

a. Iⁱ/2"-dia. I

notch ->

? Y

—>1 life" HE-1

v_y

thick-ne! of

3/₄"

door

FRONT

SIDE

(</₄" hardboard)

BOTTOM

(6³/4" x 43/s" - 3/₄" PLY.)

fixed

NOTE: make ^shelf

set of six bins