39 - Modular Wall Storage , страница 27
#8> x 2" Fh SHEET METAL SCREW
#8> x v/2" Fh WOODSCREW
Vz" LOCK NUT
V2" WING NUT
(14" x 14%" 14" HDBD.)
ATTACH ^ " SHORT HANGING BRACKET FLUSH WITH TOP EDGE OF BACK
NOTE: ALL X^ \
%" PLYWOOD EXCEPT BACK
(714" X 13%")
CUT SLOT TO FIT YOUR CIRCULAR SAW
THICK-NESS £ of t PLY.
y cordless drill is one tool I like 0 have handy — and charged up. So I decided to build a storage unit big enough to hang the drill and hold the battery charger.
Here again, the top (E) and bottom (F) fit in rabbets in the sides (G), see Fig. 3. And there's a curved "scoop" in the sides, see pattern below.
But this time, the front edge is taller so it matches the height of my charger. Also, I drilled a hole in the back (H) for the power cord on the charger to pass through.
CRADLES. The drill hangs on two plywood cradles (I) screwed to the back, see Fig. 3a. As before, cut a scrap first to see if the body of the drill fits in the cradles.
NOTE: 1" x 1" GRID PATTERN SHOWN
PATTERN FOR SIDE