Woodworker's Journal 101-Projects-for-Woodworkers, страница 176

i r >

so

V

JL

t □

Jr

r."

9%-

-I

VJ I

LI_L

TABLE END v/lew

rs'i

FKOMT" VlEiAj

Fjfc. 1

from !" stock ripped to a width of IV/'. Refer to Figure 1 and Detail A for the frame dimensions. We used a blind-doweled miter joint at each corner to provide added strength. You'll want an attractive joint here, one that's clean and tight, so make measurements and cuts with special care. Use a miter box if you have one. Glue and clamp the frames and secure the laminated panel with

finishing nails driven at an angle up through the panel and into the frame. It's best to drill under-size pilot holes for the nails.

The bottom shelf (record rack) can be made next. The record dividers may be eliminated if you plan to use this piece as an end table. Cut the plywood F to size. Referring to Figure 1. rout M"-wide x %"-deep x 5"-long grooves across

169