Woodworker's Journal 1984-8-1, страница 48

_SCUT VENEER TO V PESIK.EP WiPTH rjXuSINlCn A VEN-Vy \EE R CuTTI N<5[ OR A VV\ RAZOR

V XlvSv^'f^-

soak strips ir4 solutsksr or

Very hot u/A.T"ef<! until Pliable- (po not" soak inlawed STRIRs longer than & mln.)

SAND SMOOTH , THEIsl FINISH BY CIPPIN& INTO CEFT® 6LEAR "»EHI -£jUOSS INTERIOR FINISH.

Steps one through six show the general procedure for making a bracelet. Just keep in mind that there is no hard and fast rule that dictates the size or style. If you use inlay banding for the outside strip though, the width will be determined by the pattern you choose. Veneer stock can be cut to almost any width, in fact, we've made bracelets as narrow as V* in. and as wide as 2 in.

We generally used four strips of veneer (or three strips of veneer and one strip of inlay banding) for each bracelet. However, if you prefer a thicker bracelet, simply add one or two more veneer strips.

Step 1: Select a suitable piece of veneer, then cut it (with the grain running lengthwise) to the desired width using a veneer saw or sharp razor knife. Depending upon the size of the form, the length wiil vary somewhat—just be sure it doesn't overlap when bent around the form. A length of 7 in. will be about right.

Step 2: Bring a pan of water to a boil, then remove from the heat. Soak the strips in the hot water until pliable (5-10 minutes). However, don't soak the inlay strips for more than 5 minutes or the small pieces may begin to separate.

Step 3: Remove from the water and wrap the strips around the form. Secure in place with a web clamp or masking tape and allow to dry overnight.

Step 4: Remove the strips from the form and apply glue. Be sure to cover the surfaces thoroughly.

Step 5: Apply a coat of paste wax to the form, then reassemble the strips and secure with the web clamp or masking tape. The wax will keep the veneer from adhering to the form. Allow to dry at least two hours.

Step 6: Use sandpaper to sand all surfaces smooth, particularly the edges and the ends. Deft's clear semi-gloss interior finish (also available from The Woodworkers' Store) provides an attractive final finish. A thumbtack on the end of a length of string makes it easy to dip the bracelets into the finish. Wvf