Woodworker's Journal 1993-17-4, страница 53

I.

BUO^VC

K

S

parts C overhang on each end.

By the way. before gluing the parts, it's a good idea to drive four small brads into each part C. then snip the heads off so that about '/i<< in. protrudes. Tlie brads \sill keep the parts from sliding oul of position when clamp pressure is applied. Locate the brads as shown, keeping in mind that you don't want them where the holes will be bored in step 5.

5 Once the glue has dried, remove the spacer and trim parts C flush with the ends of A and B. Make the trimming cuts with care so as not to change the length of parts A and B.

Carefully mark the center line location of the two /x in. diameter holes and bore them out. Once bored, set up a stop on the niiter gauge exactly 8 in. from the blade and crosscut the assembly through the center of the bored holes. To insure identical lengths, it's a good idea to cut both parts against the miter gauge stop.

July/August I <W3

53