Creative Woodworks & crafts 2000-04, страница 52

continued from page 57

Fig. 1. Transfer the pattern to the Fig. 2. Use cut pieces as Fig. 3. Cut on the outside

wood. Note the 9/16"-Dia. x 1/8>" templates to scribe accurate edge of the line,

deep hole for the eye. cut lines on the adjacent stock.

Fig. 4. Prum sand to the pencil line. Fig. 5. Fit the pieces together. Fig. 6. Glue the body pieces together.

Fig. 7. Cut and fit the pelvic fin out of Fig. &. Cut the pelvic fin in half. Fig. 9. Rout the outside edge of the body.

3/4" thick poplar. Do not begin or end routing at the top or

bottom ends where the wood is thin.

Fig. 10. Contourthe left pelvic fin.

52

Fig. 12. Sand the gill shims.

Creative Woodworks & Crafts

Fig. 11. Tack the tail to a scrap 2" x 4" block to safely cut the contour on the band saw.