Creative Woodworks & crafts 2004-08, страница 38

hhm

Pattern Located in Full Size Pattern Section No. 1!

SUPPLIES

Wood: wood of choice—one piece approximately 3/4" x 7-1/2"x 10-1/2"* Tools: scrcll saw with No. 5 blades (12.5 TPI); drill with No. 58 bit Temporary-bond spray adhesive Sandpaper, assorted grits Wood glue with glue brush Clear spray finish 'The pattern for this project lends itself well to enlargement and reduction, and accommodates many different formats. Please feel free to use it in any size or manner you see fit.

INSTRUCTIONS

Step 1. Using the spray adhesive, put your pattern on the wood. Step 2. Dril for all inside cuts. Cut. Step 3. Dril at the X's for relief cuts. Step 4. Put your saw taPle at 3° to the right and cut following directional arrows. Note: if tilting your table to the left, cut opposite the directional arrows. Step 5. Sand as needed. Step 6. "Paint" glue on the back half of the edges of the relief pieces. Push into relief. Step 7. Firish with clear spray finish.

For questions concerning this project, send an SASE to: Marilyn Carmin, 4569 NE 78th PL, Portland, OR 97218.m