Creative Woodworks & crafts 2004-11, страница 75

a 1-1/6" multi-spur bit in the drill press. on the band saw. that I have both a left- and right-hand piece

for both the ends and the sides.

Fig. 12. Stop the roundover approximately 1/2" from the end of top, outside edge of the side.

Fig. 13. Marking the side to determine the length of the bottom panel. Be sure to use a sharp pencil.

Fig. 15. A gauge block is used to line up the rails parallel with the bottom. Note that I used two short pieces rather than one long one because they are easier to remove when finished. You might want to pre-drill the holes in the poplar with a 1/16" drill bit; the small nails used bend easily.

the glue is thoroughly cured.

Creative Woodworks & Cr afts November 2004 • 75